ProAc Studio 130

Height on plinth and spikes 965mm (38”)
Depth 240mm (9 1⁄2”)
Width 190mm (7 1⁄2”)

Bass Driver: New 165mm (6 1⁄2”) ProAc unit with coated cone raised spider assembly for greater linearity,and large shielded magnet assembly.

Tweeter: ProAc 25mm (1”) coated silk dome with special coating and inner damping.

Crossover HQ network using the finest components with option for bi-amping/bi-wiring and utilising oxygen free cable.

Finishes
Black Ash, Mahogany, Cherry, Maple

Mode
Floor standing with spikes

Nominal Impedance: 8 ohms

Recommended Amplifiers: 15-150 watts

Frequency Response: 25hz-30khz

Sensitivity: 88.5db linear for 1 watt at 1 metre

Weight: 16kgs each with spikes and plinths

Grill: Acoustically transparent crimplene

Brochure

Project rpm 1.3 genie

Link al manuale sul sito Project


Manual turntable with S-shaped 8.6" tone-arm

Turntable
• Chassis available in matt black, glossy black, red and white
• A quiet running synchronous motor with a two-step pulley drives the platter's outside edge via a rubber belt.
• The drive motor is isolated on its own platform and completely decoupled from the plinth to eliminate vibration transmission.
• The resonance-optimised platter is made of medium density fibre.
• A inverted, chrome-plated stainless-steel axle runs on a polished metal ball in a sintered bronze bearing housing.
• Connection to the phono input of the amplifier can be made with connecting cables of your taste through the gold plated phono sockets and earth screw.
• External power supply avoids potential electro-mechanical interference.

Tonearm 8,6 S
• The turntable is supplied with Ortofon OM 3E or Ortofon 2M Red MM-cartridge fitted
• The headshell and armtube are fashioned from a single piece of aluminium.
• The horizontal bearings consist of two hardened stainless steel points and ballraces.
• Eccentrically mounted counterweight reduces cantilever forces and dynamic wow when playing warped records.
• Solid armbase permits accurate height adjustment of armtube and VTA (vertical tracing angle).
• The counterweight supplied is suitable for cartridges weighing between 4 - 9g
• Single-screw fixing of armtube allows rotation for easy adjustment of needle azimuth despite fixed headshell.
• The internal wiring consists of silver coated, high-purity copper.